[an error occurred while processing this directive]
化学工业与工程
 首页 |  在线投稿 |  期刊介绍 |  编 委 会 |  投稿指南 |  期刊订阅 |  下载中心 |  出版伦理 |  联系我们 |  English
化学工业与工程 2018, Vol. 35 Issue (4) :38-45    DOI: 10.13353/j.issn.1004.9533.20161088
化工过程与设备 最新目录 | 下期目录 | 过刊浏览 | 高级检索 << | >>
电容法脱盐工艺条件优化与脱盐性能比较
王钰, 徐世昌, 王越, 王智强, 马冬雅
1. 天津大学化工学院, 天津 300072;
2. 天津市膜科学与海水淡化技术重点实验室, 天津 300072
Optimization of Technological Conditions and Desalination Performance Comparison of Capacitive Deionization and Membrane Capacitive Deionization
Wang Yu, Xu Shichang, Wang Yue, Wang Zhiqiang, Ma Dongya
1. School of Chemical Engineering and Technology, Tianjin University, Tianjin 300072, China;
2. Tianjin Key Laboratory of Membrane Science and Desalination Technology, Tianjin 300072, China

摘要
参考文献
相关文章
Download: PDF (2169KB)   HTML ()   Export: BibTeX or EndNote (RIS)      Supporting Info
摘要 

以石墨带为电极材料,研究了工作电压、进料流量和隔网厚度等工艺条件对电容法脱盐(CDI)性能的影响。结果表明:工作电压由0.8 V增加至2.0 V时,脱盐率和质量比吸附量先增加然后趋于稳定;进料流量由48 mL/min增加至238 mL/min时,脱盐率和质量比吸附量先增加后减小;隔网厚度由0增加至1.8 mm时,质量比吸附量先减小后增加。在电压1.6 V、进料流量142 mL/min、隔网厚度1.8 mm时,CDI脱盐性能较好。在上述相同的工艺条件下,对CDI与膜电容法脱盐(MCDI)进行了对比研究。结果表明:在第1个循环的吸附阶段,MCDI脱盐率和电流效率分别比CDI增加了31.68%和36.16%;16 h循环吸脱附实验后,MCDI再生率为99.01%。表明MCDI比CDI具有更好的脱盐性能和再生性能。

Service
把本文推荐给朋友
加入我的书架
加入引用管理器
Email Alert
RSS
作者相关文章
王钰
徐世昌
王越
王智强
马冬雅
关键词电容法脱盐;   膜电容法脱盐;   脱盐率;   稳定性;   再生率     
Abstract

Graphite cloth was used as the electrode material in the capacitive deionization (CDI) cell. Effects of the technological conditions such as the operating voltage, the flow rate and the thickness of the spacer on the desalination performance of the CDI cell were discussed and analyzed. The results indicate that the desalination efficiency and the specific adsorption capacity both increase at first and then tend to be stable as the operating voltage increasing from 0.8 V to 2.0 V. Along with the increase of the flow rate from 48 mL/min to 238 mL/min, the desalination efficiency and the specific adsorption capacity both increase firstly and then decrease. With the increase of the thickness of the spacer from 0 mm to 1.8 mm, the current efficiency and the specific adsorption capacity reduce firstly and then increase. When the operating voltage is 1.6 V, the flow rate is 142 mL/min and the thickness of the spacer is 1.8 mm, the CDI cell has a better performance with the desalination efficiency of 54.76%, the specific adsorption capacity of 4.29 mg/g and the current efficiency of 10.89%. Under the same optimal technological conditions, the desalination performances of the CDI cell and the membrane capacitive deionization (MCDI) cell were studied and compared after 16 h of multiple adsorption/desorption experiments. The experiment results show that during the adsorption stage of the first cycle, the specific adsorption capacity of MCDI is 1.52 times of that of CDI. The desalination efficiency and the current efficiency of MCDI are about an increase of 31.68% and 36.16% compared to CDI, respectively. After 16 h of cyclic test, MCDI cell has a regeneration rate of 99.01%. It turns out that MCDI shows better desalination performance and recyclability than CDI.

Keywordscapacitive deionization;   membrane capacitive deionization;   desalination efficiency;   stability;   regeneration rate     
Received 2016-04-28;
Fund:

国家自然科学基金面上项目(21576190)。

Corresponding Authors: 王越,E-mail:tdwy75@tju.edu.cn     Email: tdwy75@tju.edu.cn
About author: 王钰(1990-),女,硕士研究生,研究方向为电容法脱盐技术。
引用本文:   
王钰, 徐世昌, 王越, 王智强, 马冬雅.电容法脱盐工艺条件优化与脱盐性能比较[J].  化学工业与工程, 2018,35(4): 38-45
Wang Yu, Xu Shichang, Wang Yue, Wang Zhiqiang, Ma Dongya.Optimization of Technological Conditions and Desalination Performance Comparison of Capacitive Deionization and Membrane Capacitive Deionization[J].  Chemcial Industry and Engineering, 2018,35(4): 38-45
Copyright 2010 by 化学工业与工程